E4E-B INSTALLATION GUIDE

Install the unit in the COOLEST place inside the engine compartment, away or shielded from the exhaust radiation.

If needed, you can extend the injector harness length. Unplug all injectors and plug in the E4E clips.

NOTE: Make sure that the male/female connector comes from the same set and end up on ONE cylinder. The sequence of cylinders is not important.

Then connect the GROUND wire (with a lug) to any chassis point, which is free of paint and constitutes a good connection.

NOTE: Failure to make a good ground connection will stop the engine dead.

Strap the temperature sensor to the top radiator hose.